Cat exhaust installation as

1 Raise the vehicle. If you do not have a lift, ramps, or use a jack. Take the back, so you can get. Assess the shape of all parts of the exhaust system prior to departure. If you want to start at the catalyst, the exhaust manifold or crossover pipe, be sure to order the necessary parts before you get rid of the old exhaust system.

2 Lie on your back and get under the car until you can see, where to look, the tubesConnection with the catalyst.

Exhaust System

3 Remove the old exhaust system from the rear of the machine and make your way into the future. Typically, the bolts are rusted and difficult to remove if you do not have a weapon impact. Bring to penetrate some WD-40 on the bolts.

4 Remove all the components of the exhaust system that is expected to replace. Take them out of the trailer and put aside your share. Now you should remove all the tubes. If you're brand new trailer (as proposed, because such actionsare blurred and old), cut the old work with any type of cut (a Dremel).

5 Depending on the type of trailer you have on your car, place the hook on the pieces first brand new exhaust, which is usually a less complicated for the pieces again.

6.Beginning from the front of the car, install the pieces and then put it on the exhaust pipe in front of her. Do not tighten all the way until all parties.

7 If you do notnew position is held between the sections of pipe, or buy something new or you can use the old if they have the correct diameter. It is recommended that new exhaust to avoid losses as a result.

8.Subsequently are connected to all cylinders to start protecting each section to 1. Apply a sufficient amount of torque on each bolt to ensure it is tight.

9 If they do, the back of the car, take a few steps back and correctAlignment changes. You want the exhaust above the bumper and satisfying look.

10 Check all screws and ensure that they are solid.

11 Start the machine and find any leaks could occur.

Cat exhaust installation as

sicomatic pressure cooker kluge leather messenger bag patio umbrella parts tilt